Dongguan Jisheng Automation Equipment Technology Co., Ltd.

Home

How does the labeling machine call up the label length?

Release time:

2023-02-18

Adjustment of the 1. brush device The center of the brush is aligned with the label and symmetrical on both sides, and perpendicular to the surface of the container. The overlapping gap of the pressure brush sweeping the container is 10mm ~ 15mm for a single pressure brush and 5mm ~ 10mm for a combined pressure brush. The position of the cleaning brush from the sponge is 1mm ~ 2mm. The pressure head should be 20mm lower in the absence of a bottle than in the case of a bottle.

2. label box adjustment The center line of the label box and the center axis of the label station are tangent to the label paper, and are connected to the center axis of the label plate at three points. Adjust the tangent (contact) between the label plate and the label paper, and then move the label box closer to 1mm ~ 2mm. The gap between the label paper in the label box and the banding on both sides is between 0.8mm and 1mm. If the gap is too large, it is easy to cause the label paper to shift in the label box and cause the phenomenon of oblique marking. If the gap is too small, it will cause the phenomenon of poor mark pushing. Adjustment of the label supply roller: When there is no label, the label pressure plate can be pressed to the front end of the label box, and when the label is installed, the label hook (referring to the nearby label) cannot be crushed. Adjustment of the position of the marker hook of the marker box: the upper, lower, left, and right marker hooks can be smoothly grasped on the same vertical plane and evenly stressed on the marker paper.

3. the bottle-in/bottle-out star wheel, the adjustment of the bottle-in screw, the adjustment of the bottle-in star wheel: when the bottle pressure head just overwhelms the bottle, adjust the bottle-in star wheel so that the bottle is located in the middle of the star wheel groove. Adjustment of the bottle-out star wheel: when the bottle pressing head is just lifted, adjust the star wheel so that the bottle is located in the middle of the groove of the star wheel. Adjustment of bottle feeding screw rod: the bottle feeding star wheel shall prevail. When the bottle is located in the middle of the bottle feeding star wheel groove, adjust the screw rod so that the bottle feeding side of the screw rod is close to the bottle without displacement.

Adjustment of rubber scraper and rubber roller for 4. station: there should be no gap between rubber scraper and rubber roller in the whole length. if there is gap, rubber scraper can be adjusted by adjusting eccentric bolt. The adjustment of the rubber roller and the standard plate: the standard plate and the rubber roller are only in contact with each other without any pressure. If the gap is too large, the standard board will be glued too much, resulting in gluing. If the gap is too small and the contact is too tight, the glue will be squeezed away, and there is no glue on the half of the standard board. Practice has proved that the gap between the standard plate and the rubber roller is the best between 0.1mm and 0.2mm, which can be realized by adjusting the bearing seat at the lower part of the rubber roller, and the bearing at the upper part of the rubber roller can be adjusted if necessary.

For details, welcome to consult Dongguan Machine Saint Automation Equipment Technology Co., Ltd!

Application range of spot welding machine

Labeling machine workflow

Application range of spot welding machine

Labeling machine workflow